Input Channel; Storing Channels Manually - JVC HR-J713EU Instructions Manual

38
EN
1
4
NUMBER
7
1

Storing Channels Manually

Store channels that were not stored during Auto Set Up (
4), Preset Download (
ACCESS MAIN MENU
1
Press MENU.
ACCESS CONFIRMATION
SCREEN
2
Press %fi to move the highlight bar (pointer) to
"MANUAL CH SET", then press OK or
mation screen appears.
SELECT POSITION
3
@ #
Press % fi
until an
open position in which
you want to store a
channel begins blinking,
then press OK. The
Manual Channel Set
screen appears.
2 3
2
5 6
8 9
0
4
?
OK
pg. 6) or Auto Channel Set (
#
. The Confir-
(Ex.) To store in position 12.
PR CH ID
01 25 ARD
02 CDB SKY1 09
03 10 ZDF
04 C65 RAI1
05 C31 BBC1 12
06 C32 BBC2 13
07 C33 3SAT
[ 5 ∞
]
=
: EDIT
= [X] : DELETE
[MENU] : EXIT
The blueback screen and the
programme currently being
broadcast by the selected channel
appear alternately for 8 seconds
each.
SUBSIDIARY SETTINGS (cont.)
SELECT BAND
4
Press % fi to change the
band between CH (regular)
and CC (cable), then
press

INPUT CHANNEL

5
Press the NUMBER keys to input the channel number you
want to store.
ENTER NEW CHANNEL
pg.
INFORMATION
pg. 36).
6
Press OK and the Confirmation screen appears.
CLOSE CONFIRMATION
SCREEN
7
Press MENU.
ATTENTION
PR CH ID
08 C26 E-SP
Guide Program numbers are not set when channels are
55 WEST
10 C24 SAT1
stored manually. If an attempt is made at timer program-
11 C23 OSF
ming with S
– – – –
– – – –
screen appears; set the Guide Program numbers on this
14 – – – –
screen.
Number Set" on pg. 23.
Or perform "Guide Program Number Set" (
#
.
The blueback screen and the
programme currently being
broadcast by the selected channel
appear alternately for 8 seconds
each.
Input "0" before any single number entries.
To input the registered station name (ID –
#
press until "----" (ID setting) begins blinking, then
press % fi.
For fine tuning adjustment, press
blinking, then press % fi. While tuning, "+" or "–"
appears.
When storing a channel that sends scrambled
#
broadcasts, press until "OFF" (Decoder setting)
blinks, then press %fi to set "DECODER" to "ON"
("OFF" is the default setting).
When "AV2 SELECT" is set to "AV2", the "DECODER"
setting cannot be changed (
Repeat steps 3 through 6 as necessary.
To change positions, see "Change Station Channel
Position" ( pg. 39).
If you wish to set station names other than the ones
registered in your recorder,
page 40.
V in this state, the "GUIDE PROG SET"
HOW IEW
"ATTENTION – Regarding Guide Program
PR CH ID FINE DECODER
12 CH01 – – – – +/– OFF
[ 5 ∞ ] : SELECT
] : CURSOR +=
[
: OK
[MENU] : EXIT
pg. 41),
#
until "+/–" begins
pg. 31).
"Set Stations (B)" on
pg. 46).