Input Channel; Storing Channels Manually - JVC HR-S9500EH Instructions Manual

52
EN
NUMBER
1
MENU

Storing Channels Manually

Store channels that were not stored during Auto Set Up (
or Auto Channel Set ( pg. 50).
ACCESS MAIN MENU
1
Press MENU.
ACCESS CONFIRMATION
SCREEN
2
Press %fi to move the highlight bar (pointer) to
"MANUAL CH SET", then press OK or
mation screen appears.
SELECT POSITION
3
Press % fi
until an
open position in which
you want to store a
channel begins blinking,
then press OK. The
Manual Channel Set
screen appears.
1 2 3
2
4 5 6
8 9
7
0
4
OK
. The Confir-
(Ex.) To store in position 12.
PR CH ID
01 25 ARD
02 CDB SKY1
03 10 ZDF
04 C65 RAI1
05 C31 BBC1
06 C32 BBC2
07 C33 3SAT
[ 5 ∞
]
=
: EDIT
= [X] : DELETE
[MENU] : EXIT
The blueback screen and the
programme currently being
broadcast by the selected channel
appear alternately for 8 seconds
each.
SUBSIDIARY SETTINGS (cont.)
SELECT BAND
4
Press %fi to change the
band between CH (regular)
and CC (cable), then
press

INPUT CHANNEL

5
Press the NUMBER keys to input the channel number you
want to store.
ENTER NEW CHANNEL
pg. 6)
INFORMATION
6
Press OK and the Confirmation screen appears.
CLOSE CONFIRMATION
SCREEN
7
Press MENU.
ATTENTION
PR CH ID
08 C26 E-SP
After you have stored channels manually, be sure to
09 55 WEST
10 C24 SAT1
perform Guide Program Number Set (
11 C23 OSF
get proper results from S
12 – – – –
13 – – – –
14 – – – –
.
The blueback screen and the
programme currently being
broadcast by the selected channel
appear alternately for 8 seconds
each.
Input "0" before any single number entries.
To input the registered station name (ID –
press until "– – – –" (ID setting) begins blinking, then
press %fi.
For fine tuning adjustment, press
blinking, then press %fi. While tuning, "+" or "–"
appears.
When storing a channel that sends scrambled
broadcasts, press until "OFF" (Decoder setting)
blinks, then press %fi to set "DECODER" to "ON"
("OFF" is the default setting).
When "AV2 SELECT" is set to "VIDEO", "S-VIDEO", or
"SAT", the "DECODER" setting cannot be changed
( pg. 39).
Repeat steps 3 through 6 as necessary.
To change positions, see "Change Station Channel
Position" ( pg. 53).
If you wish to set station names other than the ones
registered in your recorder,
page 54.
V timer recording.
HOW IEW
PR CH ID FINE DECODER
12 CH01 – – – – +/– OFF
[ 5 ∞ ] : SELECT
] : CURSOR +=
[
: OK
[MENU] : EXIT
pg. 55),
until "+/–" begins
"Set Stations (B)" on
pg. 57) in order to