Installation Diagram Of Indoor And Outdoor Units - Toshiba RAS-10SK-E x2 Service Manual

8-2. Installation Diagram of Indoor and Outdoor Units

For installation of the indoor unit, use the paper pattern on the back.
Front cabinet
Front panel
11
Filter
frame
9 Deodorizing
filter
10 Purifying
filter
Before install the wireless
remote control
• With the remote control cover
open, load the batteries
supplied correctly, observing
their polarity.
2 Wireless remote control
7
Batteries
Cover
3 Clip anchor Clip anchor
Hook
6 Pan head
wood screw
4 Remote control
holder
2 Wireless
remote
control
Air blowing directoion
Allow a clearance
for drainage
Loop the connective cable
(about 100 mm in diameter
and 300~350 mm long).
Hook
1 Installation
plate
Hook
8 Mounting screw
5 Shield pipe
Connect to
another
indoor unit.
Electric
parts cover
– 20 –
For the rear and left piping
Insert the remote control holder
cushion between the indoor
unit and wall, and lift indoor
unit to make work easier.
Do not allow the drain hose to
get slack.
Make sure to run the drain
hose sloped downward.
The auxiliary piping can be
connected the left, rear left,
rear, right or bottom.
Right
Rear
Bottom
Insulation of refrigerant pipes
insulates the pipes separately,
not together.
Extension
drain hose
(Option:
RB-821 SW)
6 mm thick heat resisting
polyethylene foam
Wall
Cut the piping hole
sloped slightly
Rear left
Left