JVC HR-J580EK Instructions Manual page 13

Check the Results
When
following examples on the VCR display panel:
Finish Off
Select the Video channel or AV mode, then make sure that all necessary stations
have been stored in the VCR's memory by using the A and B buttons.
If station names (ID —
station name will be displayed at the top left corner of the TV screen for about 5
seconds each time you select a different channel via the VCR.
The VCR is now set up.
IMPORTANT
• re-running setup Auto Setup or Preset Download may not behave as
TV
TV/VCR AUDIO – –:– –
1 2 3
2
4 5 6
VPS/PDC DAILY/QTDN. WEEKLY/HEBDO
8 9
7
0000 AUX 4
0
• duplicate stations You may be able to receive the same station from two
START STOP
DATE PR
DEBUT FIN
EXPRESS
?
1 PROG 30 SEC
• manual station setting If any of the above problems occur, refer to
• rf connections In certain reception conditions, the Video Channel may not
IF YOU HAVE ANY DIFFICULTY WITH THE ABOVE PROCEDURES CALL THE JVC
CUSTOMER SERVICE HOT LINE ON 0870 330 5000
Auto Setup or Preset Download
The Preset Positions have been set successfully
Perform Clock Set on page 49.
Go to
Step 3
The Preset Positions have not been set successfully
Make sure the cables are connected properly to the VCR and turn
the VCR off and then on again. Try
again. Then, perform Clock Set on page 49.
You can now use it to play and record.
described if it has already been run on the VCR. This is because some of the
information gathered on the first Auto Setup or Preset Download is retained in
memory and that part of the process may be skipped by the VCR.
different transmitters in which case Auto Setup will detect and store both. It is
normal for one transmitter to give you a better quality picture than the other; to
delete those stations which have a poor picture
page 45 to input station names (
station preset positions (
be set correctly and interference may appear in the TV picture while the VCR's
power is on. Set your Video Channel manually. (
three step quick start
has finished, you will see one of the two
.
pg. 47) have also been stored in the VCR's memory, the
Change Station Name
pg. 46,
Change Station Preset Position
Auto Set Up or Preset Download
on page 45.
Delete A Channel
). You can also change
).
pg. 42,
Video Channel Set
13
)