JVC HR-J580EK Instructions Manual page 11

SELECT THE VIDEO CHANNEL
When
VCR:
rf cable only
Cable to connect the VCR to the TV, you will
see this display. The number is the channel on
TE PR
the TV that the
video channel. In the example, we have presumed that channel 36 is vacant and
have set the VCR to 36:
TV
– –:– –
TV/VCR AUDIO
1 2 3
2
4 5 6
VPS/PDC DAILY/QTDN. WEEKLY/HEBDO
7 8 9
0000 AUX 4
0
START STOP
DATE PR
DEBUT FIN
EXPRESS
PROG ? 30 SEC
1
rf and scart connection
chosen to connect the VCR to the TV with both
the RF Cable and a 21-pin SCART Cable (not
provided), you need to press the
the Remote Control until the figure reads '– –'. This is because you will use the
TV in AV mode to view video pictures and therefore do not need a dedicated
video channel.
FINISH AUTO SETUP
Press O and move on to
oops!
Setup
has finished, you will see the following display panel on your
Auto Setup
If you have only used the RF
has chosen to be the
Auto Setup
Now tune the TV set to channel 36 (refer to TV manual if
necessary); you should see two vertical white bars appear
on the TV screen. If the bars do not appear or are not
clear, choose another vacant channel and try again. If you
cannot obtain the vertical white bars on any channel
between 22 and 69, consult your local JVC dealer.
Step 2
If there is a power cut or you accidentally press a button during
, turn the VCR off and then on again. Re-perform
three step quick start
If you have
button on
PR
to check the results.
VCR
REVIEW
VCR
REVIEW
Auto
.
Auto Setup
11