Table of Contents
Advertisement
8
Auto Set Up
Auto Channel Set/Auto
Clock Set/Auto Guide
Program Number Set
1
1
4
7
/
2
1
¶
1
ATTENTION
Once you have performed Auto Set Up, even if the
recorder's memory backup has expired, all the stored
stations and their Guide Program numbers remain in the
recorder's memory and the recorder will not perform Auto
Set Up again. You only need to set the clock. (
If you have moved to a different area, perform each setting
as required.
Tuner setting
pg. 34
Clock setting
pg. 42
Video Plus+ Guide Program number setting
If a new station starts broadcasting in your area, perform
both tuner setting (
pg. 34) and Video Plus+ Guide
Program number setting (
q
¡
2
3
5
6
8
9
0
4
TV PROG
3
¡
7
8
4
¢
pg. 42)
pg. 10
pg. 10).
The Auto Set Up function sets the tuner channels, clock and
Video Plus+ assigned Guide Program numbers automatically
when the
power on the recorder after you plug the mains power cord into
a mains outlet.
Before starting the following procedure, make sure that the TV
aerial cable is connected to the recorder and that the recorder's
mains power cord is connected to a mains outlet (
PERFORM AUTO SET UP
1
Press
"Auto" appears on the display panel and blinks; do
NOT press any button on the recorder or remote
control until the display panel shows the current
time or "CH1" or "--:--". (Refer to box on page 9.)
Auto Set Up usually takes about 4 – 12 minutes;
the duration differs by the area.
1
Auto channel set function takes place first; it assigns
automatically all receivable stations in your area.
Auto clock set function sets the clock automatically.
During auto channel set, the recorder recognizes each
station name of the detected stations and stores them
in the recorder's memory, then automatically sets
Video Plus+ assigned Guide Program number for
those stations according to the broadcast area.
NOTES:
1
If the TV power is on and its
VIDEO channel or AV mode
is selected during Auto Set
Up, the AUTO SET screen
will appear. As Auto Set Up
progresses, the "
the screen moves from left
to right.
If there is a power cut, or if
you press
while Auto Set Up is in
progress, Auto Set Up will
be interrupted; be sure to turn off the recorder power once and
press
to turn the power back on to re-start Auto Set Up.
INITIAL SETTINGS (cont.)
button on the recorder/remote is first pressed to
on the recorder or remote control.
" mark on
0
[MENU] : EXIT
or MENU
Beginning
pg.4).
AUTO SET
PLEASE WAIT
+
+
+
End
Advertisement
Table of Contents
