Table of Contents
Advertisement
Index Search
Your recorder automatically marks
index codes at the beginning of
each recording. This function gives
you quick access to any one of 9
index codes in either direction.
NOTE:
Before starting, make sure the
recorder is in the Stop mode.
ACTIVATE INDEX SEARCH
1
Press PUSH JOG
"£ 1" is displayed on screen and search begins in
the corresponding direction.
To access index codes 2 through 9, press PUSH JOG
or
repeatedly until the correct index number is
displayed.
Ex.: To locate the beginning of B from the current
position, press PUSH JOG
To locate the beginning of D from the current
position, press PUSH JOG
A
–2
When the specified index code is located, playback
begins automatically.
Counter Memory
Returns to the counter reading of "0:00:00" to conveniently find
a specific place on the tape automatically.
SET COUNTER MEMORY
1
Press C. (COUNTER) RESET during playback at a point
you wish to locate later. The counter reads "0:00:00".
Then press C.MEMORY, and "M" appears in front of the
counter digits.
ACTIVATE COUNTER
MEMORY
2
When you wish to return to the designated point, press
STOP and then REW or FF.
The tape rewinds or fast-forwards and stops at about
0:00:00 automatically.
To cancel Counter Memory, press C.MEMORY again.
or
(™ or £). "™ 1" or
twice.
once.
Current position
B
C
D
E
F
–1
1
2
3
Index number
Repeat Playback
Your video recorder can automatically play back the whole tape
£ 2
20 times repeatedly.
START PLAYBACK
1
Press PLAY.
ACTIVATE REPEAT
PLAYBACK
2
Press PLAY and hold for over 5 seconds, then release.
The Play indicator ($) on the display panel blinks
slowly.
The tape plays 20 times automatically, and then
stops.
STOP PLAYBACK
3
Press STOP at any time to stop playback.
NOTE:
Pressing PLAY, REW, FF or PAUSE also stops Repeat Playback.
NTSC Playback
Your video recorder is equipped with NTSC circuitry that can
play back NTSC tapes.
LOAD A CASSETTE
1
Insert a cassette recorded in NTSC.
START PLAYBACK
2
Press PLAY.
"NTSC" appears on the screen for about 5 seconds.
Some TVs shrink the picture vertically and place
black bars at the top and bottom of the screen. This is
not a malfunction on the part of either the video
recorder or the TV.
The picture may roll up and down. This can be
corrected using the V-HOLD control found on some
TVs. (This cannot be corrected if the TV does not
have a V-HOLD control.)
The counter and tape remaining time readings will be
incorrect.
During search, still, or frame-by-frame playback, the
picture will be distorted, and there may be a loss of
colour.
Depending on the type of TV, the top and bottom
portions of superimposed displays may be cut off
during NTSC playback.
15
Advertisement
Table of Contents
