Wiring The Control Circuit - YASKAWA VS mini J7 Series Instruction Manual

Wiring the Control Circuit

Only basic insulation is provided for the control circuit terminals.
Additional insulation may be necessary in the end product.
• Control circuit terminals
Pass the cable through wiring hole and connect. Be sure to mount the
covers on its original position.
MA MB
* SW7 can be changed according to sequence input signal (S1 to
S5) polarity.
0V common: NPN side (factory setting)
+24 common: PNP side
Refer to page 103 for SW7.
Refer to page 67 for SW8.
Wiring the control circuit terminals
Insert the wire into the lower part of the terminal block and connect it tightly
with a screwdriver.
5.5 mm
(0.22 in.)
SW7
PNP
NPN
MC
S1 S2 S3 S4 S5 SC
Wire sheath strip length must be 5.5mm (0.22in.).
SW8
FS FR FC AM AC
Screwdriver blade width
0.4 mm max
(0.016 in.)
2.5 mm max
(0.098 in.)
25