24Hr Quick Programing - JVC HR-5910U Instructions Manual

36
EN
24HR Quick
Programing
POWER
REC LINK
S VIDEO
VIDEO (MONO)L—AUDIO—R
S-VHS ET
NOTES:
If "Err" appears on the display panel, repeat the steps again.
When a menu screen is shown, you cannot use 24HR quick
programing function. Press MENU to return to normal screen,
and try again.
You can use 24HR quick programing function also when the
VCR is turned off.
For 24HR quick programing function, the program overlap
warning display does not appear even if some programs
overlap each other.
Even if a power failure occurs, the VCR keeps your timer
programs. However, the clock time, channel settings, and
other menu settings are lost.
As a result, when the power is supplied again to this VCR
after the power failure, the following will take place.
1. This VCR starts the Plug & Play setting automatically to
restore the clock time and channel setting.
2. If the clock time and channel setting are restored correctly,
each timer program you have made will start at its start
time unless its end time has elapsed.
Timer warning display
A warning appears on the
TV screen to tell you that
the timer-recording is to
start in 5 minutes if you
are not in the timer
recording standby mode at
that time. Press TIMER to
put the VCR into timer
recording standby mode. To clear the display, press
CANCEL on the Remote.
JOG dial
REW FF
PLAY
– +
CH– /+
PUSH / TURN
A.DUB
24HR QUICK
PROGRAM
INSERT
REC PAUSE STOP/EJECT
24HR QUICK
PROGRAM
–WARNING–
TIMER RECORDING
TO START SOON
(CANCEL)
TIMER RECORDING (cont.)
You can program a timer recording that starts within
24 hours. Up to 8 timer recording programs can be
made as far as a year in advance. Remember, the clock
must be set before you can program the timer (
1
or 10).
Load a cassette
Make sure the record safety tab is intact. If not,
cover the hole with adhesive tape, then load it
into the VCR.
The VCR turns on, and the counter is reset,
2
automatically.
Access 24HR quick program display.
Push 24HR QUICK PROGRAM. " " and start
time start blinking on the display panel.
3
Set program start time
Turn the JOG dial to the left or right. Then, push
the JOG dial. " " and start time start blinking on
the display panel.
One click stop of the JOG dial changes the
4
time in 5-minute intervals.
Set program stop time
Turn the JOG dial to the left or right. Then, push
the JOG dial and channel number will start
blinking.
One click stop of the JOG dial changes the
5
time in 5-minute intervals.
Set channel number
Turn the JOG dial to the left or right.
You can cancel the setting at any time by
pressing and holding the JOG dial for more
6
than 3 seconds. Repeat from the step
Engage timer recording standby mode
Press 24HR QUICK PROGRAM.
The VCR turns off automatically and "‰" is
displayed on the front display panel.
pg. 8
Program start time indicator
Program start time indicator
Program stop time indicator
3
.