Setting Cable Box Output Channel & Brand - JVC HR-5910U Instructions Manual

16
EN
Turn on the VCR and the TV, and select the VCR
channel 3 or 4 (or AV mode) on the TV.
1
4
7
1
2
Setting cable box output
channel & brand
After installation, set the cable box output's channel and
its brand correctly; otherwise, the Controller cannot
work correctly.
Turn on cable box
1
Select a channel other than channel 9 on your
cable box.
2 3
2
5 6
7
8 9
0
4
3 4 6 7
–
3 5
INITIAL SETTINGS (cont.)
Access Main Menu screen on VCR
2
Press MENU.
Access Initial Set screen
3 Press SHUTTLE PLUS %fi to move the highlight
bar (arrow) to "INITIAL SET", then press OK or
SHUTTLE PLUS #.
Access Cable Box Set screen
4
Press SHUTTLE PLUS
%fi to move the
highlight bar (arrow) to
"CABLE BOX SET",
then press OK or
SHUTTLE PLUS #.
Select cable box output channel
5
Your selection depends
on how your cable box
is connected to your
VCR.
If your cable box is
connected to your
VCR's ANTENNA IN
terminal on the rear
Press SHUTTLE PLUS %fi on the Remote until
the channel number representing the cable
box's output (CH2 – CH9) appears on the
screen.
If your cable box is connected to your VCR's
AUDIO/VIDEO IN connectors on the front panel
Press SHUTTLE PLUS %fi on the Remote until
"ON F-1 (FRONT)" appears on the screen.
If your cable box is connected to your VCR's
AUDIO/VIDEO IN connectors on the rear panel
Press SHUTTLE PLUS %fi on the Remote until
"ON L-1 (REAR)" appears on the screen.
If you do not use a cable box
Press SHUTTLE PLUS %fi on the Remote until
"OFF" appears on the screen.
INITIAL SET
CLOCK SET
LANGUAGE ENGLISH
GUIDE CHANNEL SET
= CABLE BOX SET
DBS RECEIVER SET
SELECT WITH (5,∞) AND (OK)
PRESS (MENU) TO END
CABLE BOX SET
OFF
PRESS (5,∞), THEN (OK)
PRESS (MENU) TO END