Other Problems - JVC HR-272EU Instructions Manual

52
EN

OTHER PROBLEMS

SYMPTOM
1. Whistling or howling is heard from the
TV during camcorder recording.
2. When scanning channels, some of
them are skipped over.
3. The channel cannot be changed.
4. Channel settings that were made
manually seem to have changed or
disappeared.
5. No channels are stored in the
recorder's memory.
ATTENTION
This recorder contains microcomputers. External electronic noise or interference could cause malfunctioning. In such cases, switch
the recorder off and unplug the mains power cord. Then plug it in again and turn the recorder on. Take out the cassette. After
checking the cassette, operate the unit as usual.
POSSIBLE CAUSE
The camcorder's microphone is too
close to the TV.
The TV's volume is too high.
Those channels have been designated to
be skipped.
Recording is in progress.
After the manual settings were made,
Auto Channel Set was performed.
The TV aerial cable was not connected
to the recorder when Auto Set Up was
performed.
TROUBLESHOOTING (cont.)
CORRECTIVE ACTION
Position the camcorder so its microphone
is away from the TV.
Turn the TV's volume down.
If you need the skipped channels, restore
them ( pg. 42).
9
Press to pause the recording, change
4
channels, then press to resume
recording.
Perform manual setting again.
Connect the TV aerial cable to the
recorder properly and turn off the recorder
power once, then turn the recorder power
back on again. The recorder will try Auto
Set Up again ( pg. 8).