Manual Channel Set - JVC HR-272EU Instructions Manual

42
EN

Manual Channel Set

Store channels that were not stored during Auto Set Up
( pg. 8), Preset Download (
( pg. 40).
A
Access the Main Menu screen.
Press MENU.
B
Access the Confirmation screen.
rt
Press to move the highlight bar (pointer) to
"MANUAL CH SET", then press OK or
Confirmation screen appears.
C
Select the channel position.
rt w e
Press until an open
position in which you want to
store a channel begins blinking,
then press OK. The Manual
Channel Set screen appears.
pg. 10) or Auto Channel Set
e
. The
(Example) To store in position 12.
The blueback screen and the
programme currently being
broadcast by the selected
channel appear alternately for
8 seconds each.
SUBSIDIARY SETTINGS (cont.)
D
Select the band.
rt
Press to change the band
between CH (regular) and CC
e
(cable), then press .
E
Input the channel.
Press the NUMBER keys to input the channel number you
want to store.
Input "0" before any single number entries.
To input the registered station name (ID –
until "– – – –" (ID setting) begins blinking, then press
For fine tuning adjustment, press
rt
then press . While tuning, "+" or "–" appears.
When storing a channel that sends scrambled broadcasts,
e
press until "OFF" (Decoder setting) blinks, then press
set "DECODER" to "ON" ("OFF" is the default setting).
When "L-2 SELECT" is set to "L-2" or "SAT", the "DECODER"
setting cannot be changed (
F
Enter new channel information.
Press OK and the Confirmation screen appears.
Repeat steps 3 – 6 as necessary.
G
Close the Confirmation screen.
Press MENU.
To change positions, see "Change Station Channel Position"
( pg. 43).
If you wish to set station names other than the ones registered
in your recorder, see "Set Stations (B)" (
ATTENTION
Guide Program numbers are not set when channels are
stored manually. If an attempt is made at timer programming
with the S V system in this state, the "GUIDE PROG
HOW IEW
SET" screen appears; set the Guide Program numbers on this
screen. ( pg. 25, "ATTENTION — Guide Program
Number Set")
Or perform "Guide Program Number Set" (
pg. 45), press
rt
.
e
until "+/–" begins blinking,
rt
pg. 39).
pg. 44).
pg. 47).
e
to