Troubleshooting - Panasonic WV-CP310/G Installation Manual

Troubleshooting

Before asking for repairs, confirm the causes with the following table.
Contact your dealer if a problem cannot be solved even after checking and trying the solution in the
table or a problem is not described below.
Symptom
No image displayed
Blurred image
Black line in image
Damaged power cord
sheathing
Heated portion of power
line consisting of power
cord, connector, and power
plug during use
The temperature of power
cord rises or falls when the
power cord is bent or
stretched during use
Cause/solution
• Are the power cord and coaxial cable
connected appropriately?
→
Check whether the connection is
appropriately established.
• Is the monitor brightness appropriately
adjusted, or is the contrast appropriately
adjusted?
→
Check whether the monitor settings
are appropriate.
• Is the lens cap detached?
→ Check whether the lens cap is removed.
• Is the lens of the camera soiled with dirt
or dust?
→ Check whether the lens of the
camera is clean.
• Is the focus adjusted correctly?
→ Check if the focus is adjusted correctly.
• Is the connected system controller set
to multiplexed vertical drive (VD2)?
→ Check whether the connected
system controller is set correctly.
• The power cord, power connector, or
power plug is damaged. Continuous
use of the damaged cord, connector, or
plug may cause electric shock or fire.
Disconnect the power plug immediately
and request repair from your dealer.
Reference page
19~20
–
–
–
21
9
–
27