Panasonic WV-CP310/G Installation Manual page 14

3 Installation of safety wire
The following example shows the installation of safety wire:
Important:
• Be sure to install safety wire between the camera and the installation position to prevent
unexpected injury caused by fallen camera.
• Ensure that the safety wire is installed. Consult the dealer about installation.
Attach the safety wire lug (accessory) to the screw hole of the mount
base with screw (accessory).
1 Loosen one screw in the front portion of the
camera upper case. (Either left or right)
2 Be sure to attach the safety wire lug (accessory)
with the wire lug fixing screw (M2.5 × 8 mm)
provided in the accessories.
Important:
• Be sure to attach the
with the screw provided in the accessories.
Using screw of different length may cause
camera drop or damage.
• Do not install the safety wire lug at places other
than the two screw holes of the upper case.
• Do not install the safety wire lug on the
projections of the upper case. (Install the safety
wire lug between the two projections)
• Recommended tightening torque: 0.39 N·m.
Engage the safety wire with the wire engaging hole.
Safety wire
Wire engaging
hole
1 Pass one end of the safety wire eyelet through the wire engaging hole.
2 Pass the other end of the safety wire through the eyelet.
14
safety wire lug
(accessory)
Wire lug fixing Wire engaging hole
screw (accessory)
Screws of
upper case
Safety wire lug
(accessory)