2.1 Before Installation
2.1.4 Amphenol 57JE type Connector
To connect Amphenol 57JE type (screw-attach-type 50-pin connector) to the Option Card,
follow the procedure below.
1.
The 50-pin connector (jack) on the Option Card has two hook-pins.
Remove the upper hook-pin, taking out the screw.
2.
To attach the Amphenol 57JE type (plug) to the connector, drive the accessory Screw at the
upper part, and fasten the accessory Wire Tie around the lower hook-pin and the Amphenol
57JE type, as shown.
Screw
Hook-pins
50
Option Card
50-pin connector
Accessary
Screw
Amphenol 57JE type
Accessary
Wire Tie
57JE type
When connecting a connector of the type shown
below, unscrew the lower hook-pin, too. Then drive
both accessory Screws.
Accessary
Screw
Amphenol
57JE tyoe
Accessary
Screw
50-pin
connector
Hook-pin
Hook-pin
Accessary
Wire Tie
Option Card
50-pin connector
Figure 10:
Installation