Table of Contents
Advertisement
Configuring Your Video Portal via the RS 232
About Video Portal Configuration
The Video Portal requires some basic
configurations before it can be used. It will be
necessary to find the IP-address.
Configuration via the Front Panel
As an alternative to the configuration via
RS 232 you may use the LCD panel to
configure and check the IP settings, as well as
to reboot the system. This is outlined on the
next page.
Table of
Trademarks &
Patents &
Contents
Copyright
Disclaimers
D 14074.03
10.2007
!
Make sure the Video Portal is
Off
and
connect an RS232 cable between the
Video Portal and a PC.
$
To assign a
static
IP-address, type
Xconf ip Assigment: "Static"
and
Xconf ip address <IPAddr>
To assign an
IP
Subnetmask, type
Xconf ip address subnetmask
<subnetmask>
To assign an
IP Gateway
address, type
Xconf ip address gateway
<gateway IP-address>
Safety/
To Get You
To Get You
Using the
Environmental
Up and Going
Up and Going
Video Portal
Configuring via the RS 232
"
Switch on the Video Portal.
Power switch
%
&
Restart the Video
Portal.
Note the case sensitivity!
Viewing the
Configuring
Maintenance
System Status
the Video Portal
14
TANDBERG
#
Start a terminal program on the PC and
configure it to:
115200, 8, 1, None
'
Start a WEB browser
To To configure the
and enter the
Video Portal for IP dial
IP-address of the
in, register the Video
Video Portal. Default
Portal to a gatekeeper
password: TANDBERG
and enter H.323
services. For details,
see
Video Portal
Dial Plan
Services
& Upgrade
Examples
VIDEO PORTAL
USER GUIDE
Configuring the
Contact
Information
Advertisement
Chapters
Table of Contents
