Sony Handycam Vision CCD-TRV66E Service Manual page 2

Table for difference of function
Model
Destination
Remote Commander
Lens Optical
Digital
VTR REC
Video Light
Intelligent Accessory Shoe
Time Code
Note : AEP2, UK model is 80×.
Supplied accessories
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK ! OR DOTTED LINE WITH
MARK ! ON THE SCHEMATIC DIAGRAMS AND IN THE PARTS
LIST ARE CRITICAL TO SAFE OPERATION. REPLACE THESE
COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS
APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS
PUBLISHED BY SONY.
1. Check the area of your repair for unsoldered or poorly-soldered
connections. Check the entire board surface for solder splashes
and bridges.
2. Check the interboard wiring to ensure that no wires are
"pinched" or contact high-wattage resistors.
3. Look for unauthorized replacement parts, particularly
transistors, that were installed during a previous repair. Point
them out to the customer and recommend their replacement.
CCD-TRV66E
AEP1, AEP2, UK, E, HK, AUS, CN
EE, NE, RU
RMT-708 RMT-708
20× 20×
360× (Note) 360×
®
® ®
SAFETY CHECK-OUT
After correcting the original service problem, perform the following
safety checks before releasing the set to the customer.
CCD-TRV77E
AEP
RMT-717
20×
80×
®
®
1 Wireless Remote Commander (1)
RMT-708 : CCD-TRV66E
RMT-717 : CCD-TRV77E
2 AC-L10A/L10B/L10C AC power adaptor (1),
Mains lead (1)
3 NP-F330 battery pack (1)
4 CR2025 lithium battery (1)
The lithium battery is already installed in your
camcorder.
5 R6 (size AA) battery for Remote
Commander (2)
6 A/V connecting cable (1)
7 Shoulder strap (1)
8 2-pin conversion adaptor (1)
CCD-TRV66E : E, HK
9 21-pin conversion connector (1)
CCD-TRV66E : AEP, EE, NE, RU, UK/CCD-TRV77E
•
4. Look for parts which, through functioning, show obvious signs
of deterioration. Point them out to the customer and
recommend their replacement.
5. Check the B+ voltage to see it is at the values specified.
6. Flexible Circuit Board Repairing
• Keep the temperature of the soldering iron around 270˚C
during repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
— 2 —
Remark
® : With FK-8500 block S005, S007
® : With VL-23 board
® : With VC-214 board (4/10) IC701
Abbreviation
HK : Hong Kong Model
AUS : Australian Model
CN : Chinese Model
EE : East European Model
NE : North European Model
RU : Russian Model