Turning On The Power - JVC UX-S57 Instructions Manual

Turning On the Power

To turn on the unit, press STANDBY/ON
(or on the unit).
The STANDBY/ON lamp on the unit lights
green.
• When you press the source button—3/8 CD,
FM/AM and AUX (or AUX/DVD on the unit), the unit
automatically turns on and starts playback if the source is
ready.
• Pressing one of the disc eject buttons (CD10 – CD50)
also turns on the unit. (See page 17.)
To turn off the unit (standby), press STANDBY/ON
on the unit) again.
The STANDBY/ON lamp on the unit lights red.
• "0:00" flashes on the display until you set the built-in
clock. After setting the clock, the clock time will appear on
the display while the unit is on in standby mode.
• A little power is always consumed even while the unit is in
standby mode.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
When you unplug the AC power cord or if a power
failure occurs
The clock is reset to "0:00" right away, while the tuner preset
stations will be erased in a few days.
To turn off the unit automatically (Auto Standby)
Using the Auto Standby function, the unit automatically turns
STANDBY/ON itself off if no sound comes in for more than 3 minutes when
"CD" is selected as the source.
If an operation is done within this 3-minute period, the Auto
Standby function is canceled temporarily even though no
sound comes in.
• You can also turn off the unit automatically by using the
Sleep Timer. (See page 24.)
On the remote control ONLY:
To activate the Auto Standby function,
press A.STANDBY.
(or
The AUTO STANDBY indicator lights up
on the display.
• When no sound comes in, the AUTO STANDBY indicator
starts flashing on the display. About 5 seconds before the
unit turns itself off, "AUTO STANDBY" starts flashing on
the display.
To deactivate the Auto Standby function, press
A.STANDBY.
The AUTO STANDBY indicator goes off.
Continued
A.STANDBY
AUTO STANDBY indicator
AUTO
STANDBY
10