Charger Installation
The Handset uses a rechargeable 2.4V nickel-metal hydride cell (NiMH) pack and comes with a battery Charger. Place the Handset
in the Charger when not in use.
To plug the Handset Charger into AC power:
Figure 12. Handset Charger Power Connect
Getting Started
AT&T SB67040 Cordless Accessory Handset User's Guide
1. Plug the power adapter into an electrical outlet not controlled by a
2. Plug the small end of the power adapter into the jack on the
3. Route the cord through the slot, as shown in Figure 12.
wall switch.
underside of the Charger.
27