Connecting Speakers - JVC MX-DVA9 Instructions Manual

AM antenna
ANTENNA
1
2
AM loop antenna
(supplied)
1
Connect the AM loop antenna to the AM
LOOP terminals as illustrated.
• If the AM loop antenna wire is covered with
vinyl, remove the vinyl by twisting it as
shown in the diagram.
2
Turn the AM loop antenna until you have the
best reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered wire
to the AM EXT terminal and extend it horizontally. The AM
loop antenna must remain connected.
For better reception of both FM and AM
• Make sure the antenna conductors do not touch any other
terminals and connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
Vinyl-covered wire
(not supplied)
AM EXT
AM LOOP
FM 75
COAXIAL

Connecting Speakers

IMPORTANT: Use only speakers with the same speaker
impedance as indicated by the speaker terminals on the
rear of the unit.
To connect front speakers
Speaker cords
(red/black)
RIGHT
Black
RIGHT
Right front speaker
1
Open the speaker terminal.
2
Insert the end of the speaker cord into the
terminal.
Match the polarity (colors) of the speaker terminals: Red
(+) to red (+) and black (–) to black (–); Blue (+) to blue
(+) and black (–) to black (–).
3
Close the speaker terminal.
– 7 –
1
2
Red
Speaker cords
FRONT
(red/black)
SUBWOOFERS
LEFT
Black
LEFT
MAIN
SPEAKERS
CAUTION: SPEAKER
IMPEDANCE
6 16
Blue
Speaker cords
(blue/black)
Left front speaker
3