DataCard SR200 User Manual page 25

Printing Data
Printing data that None
overlaps with the
YMC Ink
UV ink data outside
the MAC address
printing area
K Ink
Printing data inside None
the MAC address
YMC Ink
area
K Ink
UV Ink
The driver compares printing data for each type of ink to determine whether there are any
overlapping pixels. Priority is given to the "Print in 2 panels" setting.
Priority of Data
SR200 & SR300 Printer User Guide
• Specify the number of retransfer panels used to print one side of a card. UV and
YMCK inks cannot be transferred in the same area on the same retransfer panel, so
this setting determines what data will print. The following table shows the result for
data outside the MAC address area and data overlapping the MAC address area.
Setting for Number of Retransfer Film Panels to Use
1 Panel
Print in 1 panel
Print in 1 panel
(The YMC ink is not
printed in areas
where it overlaps
with the UV ink.)
Print in 1 panel
(The UV ink is not
printed in areas
where it overlaps
with the K ink.)
Print in 1 panel
Print in 1 panel
(Does not print
using the YMCK
ink.)
Prints the MAC address only
The MAC address data is always printed using the UV panel. The area can knock
•
out other printing.
Image files are processed in the order registered and shown in the File Information
•
area. Newer data will replace older data if it overlaps.
Extracted text has higher priority than an image file and prints on top of any image.
•
Page Split overrides extracted data and any image files.
•
Auto 2 Panels
Print in 1 panel Print in 2 panels
Print in 2 panels Print in 2 panels
Print in 2 panels Print in 2 panels
Print in 2 panels
Print in 2 panels Print in 2 panels
Print in 2 panels Print in 2 panels
21