Removal And Replacement Of The Front Or Rear Door; Removal; Replacement - IBM T00 Service Manual

Removal and Replacement of the Front or Rear Door

It is possible that inspection or service procedures for certain drawers might require removing the front or
rear door for better access. If this is necessary, follow these instructions.

Removal

This section covers the removal procedure for the front or rear door.
1. Open the door of the rack.
2. Remove the door by lifting it up and out.
1 Rack Cabinet
2 Front Rack Door
3 Door Hinge
3. If necessary, remove the hinge bracket by removing the mounting screws that attach the bracket to the
rack.
4. If necessary, also remove the latch plate by removing the mounting screws that attach the plate to the
rack.

Replacement

This section covers the replacement procedure for the front or rear door.
1. Install the hinges on the rack by positioning them on the rack and inserting and securely tightening the
screws.
2. Install the latch plate.
3. Install the bottom hinge pin on the door. The bottom hinge pin is the longest of the two hinge pins on
the door.
4. Install the top hinge pin on the door. The top hinge pin is the shortest of the two hinge pins on the
door.
5. Position the door at the rack with the hinge pin ends slightly above and adjacent to the hinges on the
rack. Lower the door so the hinge pins slide into the hinges.
6. Close the door on the rack.
1
2
4
3
4
3
6
5
4 Hinge Retaining Screws
5 Door Latch
6 Door Latch Mounting Screws
Chapter 3. Removal and Replacement
39