Table of Contents
Advertisement
Listening to the Radio
Tuning in to a Radio Station
1
Press
or
Example: When FM is selected as the
source
Preset number (
STEREO indicator
2
Press
or
select a radio station (frequency).
• You can also select a radio station using the
automatic tuning. Refer to "Automatic
tuning" below.
• When the System receives an FM stereo
broadcast, the STEREO indicator lights on
the display window.
■ Automatic tuning
Hold down
or
changing.
When the System receives a broadcast, the
frequency automatically stops changing.
To manually stop searching, press
■ To switch the FM reception (stereo/
monaural)
If the FM station has poor reception, press
The MONO indicator lights on the display window.
Reception will improve though stereo effect is lost.
To restore the stereo effect, press
(MONO indicator goes off).
14
.
right column)
Frequency
repeatedly to
until the frequency starts
or
.
again
Storing (presetting) Radio
Stations
You can store up to 30 FM and 15 AM radio
stations.
• There is a time limit in doing the following steps.
If the setting is canceled before you finish, start
from step 1 again.
1
Tune in to a radio station you want
to store.
• Refer to "Tuning in to a Radio Station"
shown on the left.
2
Press
• The preset number starts flashing for about
5 seconds.
3
While the preset number is
flashing, press the number
buttons to select the preset
number which you want to store
the station into.
• Refer to "Using the number buttons" (
.
page 8).
4
While the selected number is
flashing, press
• "STORED" appears on the display window
and the tuned radio station is stored.
NOTE
• The type of FM reception (stereo/monaural) is also
stored (
• Storing a new station to a used number erases
the previously stored station.
Tuning in to a Preset Radio
Station
While FM or AM is selected as the source...
Use the number buttons to select the
preset number of the radio station you
want to tune in to.
Refer to "Using the number buttons" (
.
.
left column).
page 8).
Advertisement
Table of Contents
