Table of Contents
Advertisement
Connecting a Digital Audio
Player
■ To listen to a Digital Audio Player
To the audio output
NOTE
• The System automatically switches the source to
LINE when the connected Digital Audio Player
starts to play—QP Link (
• The sound signal from the Digital Audio Player
cannot be transmitted through the LINE OUT
jack.
■ To record on a Digital Audio Player from the
System
Main unit (front view)
To the audio input
NOTE
• Before recording on a Digital Audio Player,
deactivate QP Link (
connect the Digital Audio Player to the LINE IN
jack; otherwise, LINE will be selected as the source
and the recording will stop.
Do not connect the AC power cord until all other connections have been made.
Main unit (front view)
Stereo mini plug audio
cord (not supplied)
page 18).
Stereo mini plug audio
cord (not supplied)
page 18) or do not
Connecting the Power Cord
AC outlet
• After making all other necessary connections,
connect the power cord.
• When you unplug the power cord or if a power
failure occurs, the clock is reset to "0:00" and the
timers will be canceled. You will need to set the
clock (
page 8) and the timers (
-21) again.
Disabling the Demonstration
Display
When you connect the power plug into the AC
outlet, "Hello" then "DEMO START!" appears on
the display window and the demonstration display
starts.
To deactivate the demonstration display, follow the
procedure below:
While the power is turned off...
Hold down
on the main unit until
"DEMO CLEAR" appears on the
display window.
■ To activate the demonstration display again
While the power is turned off...
Hold down
on the main unit until "Hello"
appears on the display window.
• The System will be turned on and the
demonstration display will start.
NOTE
• To stop the demonstration display, operate the
System. "DEMO OFF" appears on the display
window.
Introduction
Main unit (rear view)
page 19
7
Advertisement
Table of Contents
