Connecting Speakers - JVC FS-S57 Instructions Manual

Getting Started
AM antenna
1
Vinyl-covered wire
(not supplied)
2
1 Connect the AM loop antenna to the AM
LOOP terminals as illustrated.
2 Turn the AM loop antenna until you have the
best reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered wire
to the AM EXT terminal and extend it horizontally. The AM
loop antenna must remain connected.
For better reception of both FM and AM
• Make sure the antenna conductors do not touch any other
terminals or connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
7
(continued)
ANTENNA
AM loop antenna
(supplied)

Connecting Speakers

To connect speakers
You can connect the speakers using the speaker cords.
1
2
RIGHT
Speaker
cord
Right speaker
1 If the cords are covered with insulation,
remove a short section of insulation at the
end of each cord by twisting and pulling it
off.
2 Hold the clamp of the speaker terminal.
3 Insert the end of the speaker cord into the
terminal.
Match the polarity of the speaker terminals: red cord to
ª and black cord to ·.
4 Release your finger from the clamp.
IMPORTANT:
• Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the unit.
• DO NOT connect more than one speaker to one
speaker terminal.
3,4
SPEAKERS
LEFT
Speaker
cord
Left speaker