Channel Lockout - Uniden UBC3300XLT Owner's Manual

1:CONVENTIONAL by rotating the VFO and pressing
E.
3. Select the channel number of the stored frequency to be
delayed by rotating the VFO and pressing E.
4. Select 2:DELAY and press E.
5. Rotate the VFO to select 1:ON or 2:OFF and press E.
6. For Search mode, select 1:SERVICE OPTION /
2:CHAIN SEARCH/3:DELAY by rotating the VFO
and pressing E, then set to 1:ON or 2:OFF the same
way as the Scan mode setting.

Channel Lockout

You can lockout any channel so it is not checked during
normal scanning. You can restore the channel to scanning
when you wish.
Lockout in Hold Mode
1. Press HOLD/MAN.
2. Select a channel.
a. Enter the channel number using
the keypad.
b. Press HOLD/MAN again.
––– OR –––
Rotate the VFO up or down to change
the channel.
3. Press L/O to lockout the channel.
L/O appears on the display.
Lockout in Scanning Mode
If the scanner keeps stopping on a particular channel due to
noise or frequent transmissions, you may want to keep that
channel from scanning.
1. Wait until the scanner stops on the channel.
2. Then press L/O.
3. The scanner immediately resumes scanning because the
locked out channel is no longer in the scanning sequence.
Lockout Tips Write down your locked-out channels and
put in a convenient place in case you need
to restore them.
33
CH/
FRQ
HOLD/
RSM
MAN
SCAN AIR/STEP SEARCH
MENU/BACK TRUNK
L/O
REVERSE SELECT
.
E
C 001
141.5000 FM
UNIDEN Group A