Changing The Priority Channel; Priority Channel Plus Scan - Uniden UBC3300XLT Owner's Manual

Changing the Priority Channel

You cannot eliminate the Priority Channel, but you can
change it to any one of the 100 available channels in each
bank.
1. Press HOLD/MAN.
2. Select a new Priority Channel:
a. Enter the channel number using
the keypad.
b. Then press HOLD/MAN again.
3. Press and hold PRI for 2 seconds to
designate this channel as your new
Priority Channel.
Two beeps indicates that the Priority
Channel has been changed. The P
icon appears on the display.
Note: • Priority in Trunking mode works just the same,
except you set them for talkgroup IDs, instead of
setting priorities for channels. The scanner only
checks priority talkgroups between transmission,
in 4 second intervals.
• Priority Scan is disabled while M, E or L (Trunking
type) icons are illuminated (a beep will sound if you
try to scan). To make it possible, turn OFF each
function then press PRI to select PRIORITY ON.

Priority Channel Plus Scan

You can scan only the Priority Channels (except for the lock
out channels) in the banks you selected. To activate Priority
Channel Plus
(Only in Scan mode):
1. Press PRI to select PRIORITY PLUS.
2. Press PRI to select PRIORITY ON or PRIORITY
OFF on the display to deactivate Priority Channel Plus
Scan.
Note: Priority or Priority Plus Scan are disabled while Search
mode is selected.
UHF TV 1
UNIDEN Group A
35
CH/
FRQ
HOLD/
RSM
MAN
SCAN AIR/STEP SEARCH
MENU/BACK TRUNK
L/O
REVERSE SELECT
.
E
C 001
512.0000 FM