Canon PIXMA MP620 Series Getting Started page 15

Go to Step
0.
Go to Step
O.
Windows Vista
Windows XPI
2000
Windows
,,---
• If the program does not start
automatically, double-click the CO-
ROM icon on the computer. When the
CD-ROM contents appear, double-click
MSETUP4.EXE.
Turn on the computer, then insert the
Setup CD-ROM into the CD-ROM drive.
The setup program should run automatically.
~
1;;1;:1
• Operating noise continues for about
30 seconds until the machine turns off.
Make sure that the POWER lamp (B)
stops flashing.
Press the ON button (A) to TURN
OFF THE MACHINE.
Setup the Machine and the Computer
" locate and install driver software (recommended)
W,ndows wdl9\llde you thfouqh ~ proc~ of mstallill9 drlY6 soft~rf
fOfyov<oHYKt.
.. Ask me again later
Wtn~
""II iISk
I~,n
the not
(1fM
you plug ,n your dl!Yi'ct o.1oq
on.
e
Don-t show this message again for this device
YPUf
d~{e
lOttU not honchon uotd you InSUll
dnv~ ~oftware.
Windows needs to install driver software for your
series
If the Found New Hardware or Found New
Hardware Wizard screen appears:
1
Remove the USB cable connected to
your computer.
The screen may close. In this case, proceed
from
O.
2
Click Cancel to quit the screen.
3
Proceed from
O.