Panasonic CY-VHD9500U Operating Instructions Manual page 12

Installation
E
N
G
L
I
S
WARNING:
H
≥ Have a professional technician wire and install the product.
7
Professional skill and experience is required to wire and install the product. Improper
installation could result in failure of safety equipment resulting in accident and injury.
For safety's sake, always ask the store from which you purchased the product to install and wire it
for you.
Caution:
≥ Wear gloves for installation work to protect yourself from injuries. Failure to heed this caution may
result in an accident and/or injury.
≥ Wear goggles or protective eyewear to shield your eyes from airborne metal particles during drilling.
Failure to heed this caution may result in an accident and/or injury.
Introduction
A sample installation is shown below for your reference.
First remove the headliner. Next, fi rmly attach the included upper and lower slide plates and base plate to the
two ceiling reinforcement crosspieces. Finally replace the headliner as it was and attach the main unit.
Wiring
26
CY-VHD9500U
Ceiling reinforcement
crosspieces
Slide plate (upper)
Slide plate (lower)
Base plate
CY-VHD9500U
Work Flow
Note:
≥ The fi gure below shows installation in a simplifi ed
way. Do rely on this fi gure alone as the basis
for installation. Instead, be sure to follow the
procedure on the following pages.
Ceiling
reinforcement
crosspieces
Ceiling panel
CY-VHD9500U
Front cover
There are fi ve main steps to install the main unit.
For each step, follow the detailed procedures on
page 28`35.
1
Remove the headliner from
the vehicle for installation
(page 28).
2 Attach the upper and lower
slide plates and base plate
to the ceiling reinforcement
crosspieces (page 28, 29).
3
Wire the unit and replace the
headliner (page 30, 31).
4
Get ready to attach the main
unit (page 32, 33).
5 Connect the wires and attach
the main unit (page 34, 35).
CY-VHD9500U
E
N
G
L
I
S
H
8
27