Data Master; Illumination - Raymarine i60 Installation And Operation Instructions Manual

6.3 Data master

Where a system contains more than one unit capable of
displaying a data type, the unit physically connected to the
transducer must be set as the data master and any other units
set as a repeater.
Setting a unit as data master
1. Refer to the Intermediate calibration section for details on
how to set your unit as data master.
Getting started

6.4 Illumination

Adjusting the backlight level
The backlighting can be adjusted using the power button.
During normal operation:
1. Press and hold the Power button for approximately 1 second
to display the backlight page.
2. Use the VMG or Tack buttons to adjust the backlight to the
required level.
Note: The backlight page will time-out after 8 seconds of
inactivity.
31