Raymarine i60 Installation And Operation Instructions Manual page 33

3. Use the VMG or Tack buttons to turn user calibration on and
off.
4. Press the Power button to display the wind angle response
page.
5. Use the VMG or Tack buttons to set the required wind angle
response values.
6. Press the Power button to display the wind speed response
page.
7. Use the VMG or Tack buttons to set the required wind speed
response values.
8. Press the Power button to display the VMG response page.
9. Use the VMG or Tack buttons to set the required VMG
response values.
10. Press the Power button to display the wind speed page.
11. Press the VMG or Tack buttons to display the wind speed
calibration page.
+
VMG
12. Use the VMG or Tack buttons to adjust the wind speed
calibration value to 0.7.
13. Press the Power button to display the boat show mode page.
14. Use the VMG or Tack buttons to switch boat show mode
on and off.
15. Press the Power button to display the factory reset page.
16. Use the VMG or Tack buttons to reset unit's settings to
factory default values.
17. Use the VMG or Tack buttons to adjust the current values
on each page.
18. To exit the dealer calibration pages at any time press and
hold the Power and True / App buttons simultaneously for
approximately 2 seconds.
Note: User calibration access, wind speed and boat show
mode pages are not available on the i60 Close hauled wind.
Getting started
CAL
CAL
CAL VM G
CAL
KTS
CAL
Ta ck
CAL
CAL
D12495-1
D12496-1
D12497-1
D12498-1
D12499-1
D12500-1
D12501-1
33