Data Master - Raymarine i60 wind Installation And Operation Instructions Manual

6.3 Data master

Where a system contains more than one unit
capable of displaying a data type, the unit physically
connected to the transducer must be set as the data
master and any other units set as a repeater.
Checking the software version and
instrument status
You can check the instrument display's software
version and status by following the steps below.
Note: The i60 CH Wind instrument is a repeater
display. You cannot check or change the
instrument status of an i60 CH Wind display
From the software version page:
+
True /App
Disp lay
CAL
Disp
During normal operation:
1. Press and hold the Display and True / App
buttons at the same time for approximately 4
seconds , until the Software Version page is
displayed.
2. Press the Display button to show the Instrument
Status page.
The instrument status is displayed (r 0 = master
and r 1 = repeater).
Note: The Software Version and Instrument Status
pages are temporary pages and will time-out
automatically after 8 seconds of inactivity.
Getting started
CAL
60 5
55
4 10
50
45 15
40 20
35 25
30
lay
D12492-2
35