Toyota 2004 HIGHLANDER User Manual page 268

R
(a) Programming the HomeLink
R
The HomeLink in your vehicle has 3
buttons and you can store one program
for each button.
To ensure correct programming into the
R
HomeLink , install a new battery in the
hand- held transmitter prior to program-
ming.
The battery side of the hand- held trans-
mitter must be pointed away from the
R
HomeLink during the programming pro-
cess.
For Canadian users, follow the procedure
in "Programming an entrance gate/pro-
gramming all devices in the Canadian
market".
R
1. Decide which of 3 HomeLink
you want to program.
2. Place your hand- held garage transmit-
ter 25 to 75 mm (1 to 3 in.) away from
R
the surface of the HomeLink .
Keep the indicator light on the HomeLink
in view while programming.
268
3. Simultaneously press
hand- held garage
along with the selected HomeLink
ton.
4. When the indicator
R
HomeLink changes from a slow to a
rapid flash after 20 seconds, you can
release both buttons.
5. Test the operation of the HomeLink
pressing the newly programmed button.
If programming a garage door opener,
check to see if the garage door opens
and closes.
If the garage door does not operate, iden-
tify if your garage transmitter is of the
"Rolling Code" type. Press and hold the
programmed HomeLink
buttons
rage door has the rolling code feature if
the indicator light (on the HomeLink
flashes rapidly and then remains lit after
2 seconds. If your garage transmitter is
the "Rolling Code" type, proceed to the
R
heading "Programming a rolling code sys-
tem".
6. Repeat steps 2 through 5 for each re-
R
maining HomeLink
another device.
'04 HIGHLANDER_U (L/O 0308)
and hold the Programming a rolling code system
transmitter button
If your
R
but-
equipped,
steps 1 through 4 under the heading
"Programming the HomeLink
light on the
proceeding with the steps listed below.
1. Locate the "training" button on the ceil-
ing mounted garage door opener motor.
R
The exact location and color of the
by
button may vary by brand of garage
door opener.
guide supplied by the garage door
opener manufacturer for the location of
this "training" button.
2. Press the "training" button on the ceil-
ing mounted garage door opener motor.
R
button. The ga-
Following this step, you have 30 seconds
in which to initiate step 3 below.
R
)
3. Press and release the vehicle's pro-
grammed HomeLink
garage door may open. If the door
does open, the programming process is
complete. If the door does not open,
press and release the button a third
time. This third press and release will
button to program
complete the programming process by
opening the garage door.
2004 HIGHLANDER from Aug. '03 Prod. (OM48478U)
device is "Rolling Code"
it is necessary to follow
R
" before
Refer to the owner's
R
button twice. The