Toshiba e-Studio3511 Service Handbook page 55

Notes:
1. The digit after the hyphen in "Code" of the following table is a sub code.
2. In "RAM", the NVRAM of the board in which the data of each code is stored is indicated. "M" stands for
the LGC board and "SYS" stands for the SYS board.
Classifi-
Code
cation
200 Devel- Initialization of
opment color auto-toner
201 sensor light
amount correction
202 target value
203
204
206
207 Devel- Initialization of color auto-
opment toner sensor light amount
correction target value
208 Devel- Enforced correction of color
opment auto-toner sensor light
amount
210 Transfer 1st transfer roller bias output
adjustment
(When not transferred)
211-0 Transfer 1st transfer roller
bias output
211-1 adjustment
(Image quality
211-2 control test
pattern)
211-3
212 Transfer 1st transfer roller
bias output
adjustment
214
215
216
217
November 2003 © TOSHIBA TEC
Adjustment mode (05)
Default
Func-
Items
<Acceptable
tion
value>
All ALL
(Y,M,C,K) <0-255>
Y ALL
<0-255>
M ALL
<0-255>
C ALL
<0-255>
K ALL
<0-255>
YMC ALL
<0-255>
ALL
(color)
ALL
(color)
ALL
<0-225>
Y ALL
(color) <0-225>
M ALL
(color) <0-225>
C ALL
(color) <0-225>
K ALL
(color) <0-225>
Plain ALL
paper (black) <0-225>
Thick ALL
paper 1 (black) <0-225>
Thick ALL
paper 2 (black) <0-225>
Thick ALL
paper 3 (black) <0-225>
OHP film ALL
(black) <0-225>
2 - 35
04/05
RAM Contents
- M The value starts changing approx. 3
minutes after this adjustment started.
- M The value is automatically set during
this adjustment (approx. 2 minutes).
- M
(As the value increases, the sensor
- M output increases correspondingly.)
( Chapter 3.2)
- M
- M
- M Initializes the color auto-toner sensor
light amount correction target value.
- M Performs the color auto-toner sensor
light amount correction forcibly.
225 M When the value decreases, the 1st
transfer roller bias output increases.
The adjustment value becomes
effective when the Setting Mode (08-
541, 549 and 551) is 0 (invalid).
140 M When the value decreases, the 1st
transfer roller bias output increases.
140 M The adjustment value becomes
effective when the Setting Mode (08-
140 M 541, 549 and 551) is 0 (invalid).
148 M
135 M When the value decreases, the 1st
transfer roller bias output increases.
The adjustment value becomes
135 M effective when the Setting Mode (08-
541, 549 and 551) is 0 (invalid).
135 M
135 M
135 M
e-STUDIO3511/4511 ERROR CODE AND SELF-DIAGNOSTIC MODE
Proce-
dure
5
5
5
5
5
5
6
6
3
14
14
14
14
3
3
3
3
3