Connecting Speakers - JVC CA-HXZ3R Instructions Manual

AM (MW/LW) antenna
1
2
ANTENNA
AM EXT
AM LOOP
3
AM (MW/LW) loop
antenna (supplied)
1
If cords are covered with insulation, twist the
core of the cord at the end of each cord, then
remove the insulation.
2
Connect the AM (MW/LW) loop antenna to the
AM LOOP terminals as illustrated.
3
Turn the AM (MW/LW) loop antenna until
you have the best reception.
To connect an outdoor AM (MW/LW) antenna
When reception is poor, connect a single vinyl-covered wire
to the AM EXT terminal and extend it horizontally. The AM
(MW/LW) loop antenna must remain connected.
For better reception of both FM and AM (MW/LW)
• Make sure the antenna conductors do not touch any other terminals
and connecting cords.
• Keep the antennas away from metallic parts of the unit, connecting
cords, and the AC power cord.
Vinyl-covered wire
(not supplied)
FM 75
COAXIAL

Connecting Speakers

1
2
Speaker cords
(black/blue)
CAUTION: SPEAKER IMPEDANCE
From right
subwoofer
From main
right speaker
1
If cords are covered with insulation, twist the
core of the cord at the end of each cord, then
remove the insulation.
2
Insert the end of the speaker cord into the
terminal as illustrated.
Match the same polarity: (+) to (+) and (–) to (–).
3
Close the speaker terminals.
IMPORTANT: Use only speakers with the same speaker
impedance as indicated by the speaker terminals on the
rear of the unit.
• DO NOT connect more than one speaker to each
speaker terminal.
• DO NOT push or pull the speakers as this will
damage the foot spacers at the bottom of the
speakers.
– 7 –
3
Speaker cords
(black/blue)
RIGHT LEFT
MAIN
SPEAKERS
SUBWOOFERS
6 16
Speaker cords
(black/red)
From left
subwoofer
From main
left speaker