Table of Contents
Advertisement
-
-
Proceed as fOllows to recall and execute ari edit registered in the EDL.
-
-
-
-
-
-
-
-
-
To recall an edit using the edit number
Proceed as follows.
1
Verify that the TRANS button is not lit.
If the button is lit, p e s s it once. If it is flashing, press it twice.
2
Enter the number of the edit which you want
LO
recall, using the rightmost two
buttons of' the three EDIT NO./TRANSDUR buttons.
The edit nurnber flashes.
3
Press the RECALL(ENTRY
+
GO TO) button.
The edit specified in step
2 is recalled If you specified an edit number which
does not exist in the EDL, an 'n' appears in front of the displayed edit nurnber.
To recall an edit earlier than the current one
Press the BS(ENTRY
+
)
button.
?'he edit immediately before the currently displayed edit is recalled.
Keep pressing the button until the display shows the edit number you want. Each
time you press the button, the previous edit is recalled, up to edit 01.
If setup menu item SEtUP-26 (AUTO EDL CLEAR) has been set to On, and if an
edit has actually heen overwritten beyond edit 00, then edit 00 can be recalled by
pressing the BS (ENTRY
+m)
button after recalling edit 01. As shown below,
this rnakes it possible to recall edits up to the one with a numbe~ one larger than the
new edit (the edit preceded by 'n'),
xx+l
t-
...
t
99
t
00
+-
01
t-
...
t
nxx
To recall an edit later than the current one
Press the F'S(ENTRY
+
m)
button.
The edit immediately after the currently displayed edit is recalled.
Keep p~.essing the button until the display shows the edit nurnber you want. Each
time you press the button, the next edit is recalled, up to the new edit (the edit
preceded by 'n').
If'setup menu item SEtUP-26 (AUTO EDL CLEAR) has been set to On, and if an
edit has actually been overwritten beyond edit 00, then edit 01 can be recalled by
pressing the FS (ENTRY
+
m)
button after recalling edit 00. As shown below, this
makes it possible to recall edits up to the new edit (the edit preceded by 'n').
xx+l
4
...
-+
99
-+
00
- +
01
- +
...
nxx
To execute a recalled edit
Press the AUTO EDIT button
To
execute al1 edits
from a
recalled edit
to
the end
of
the EDL
Press the MULTI(ENTRY
+
AUTO EDIT) button.
The unit automatically executes al1 subsequent edits, beginning with the current
edit and continuing in edit nurnber order to the last edit registered in the EDL,.
7-6 (E)
j
Chaptwr 7
Managing
Edil
Data
-
Thw Edit
Decision List
(EOL)
Advertisement
Table of Contents
