NEC Univerge SV8100 Features And Specifications Manual page 2082

Issue 13.0
Program
Program Name
Number
25-07-02 System Timers for VRS/DISA –
VRS/DISA No Answer Time
25-07-03 System Timers for VRS/DISA –
Disconnect after VRS/DISA
retransfer to IRG
25-08-01 DISA User ID Setup – Password
25-13-01 System Option for DISA – VRS
Message Access Password
25-15-01 DISA Transfer Target Setup –
DISA Transfer Target Area at
Wrong Dial
25-15-02 DISA Transfer Target Setup –
DISA Transfer Target Area at No
Answer or Busy
25-16-01 DID/DISA Talkie Base Setup –
Single Digit Timer
25-16-02 DID/DISA Talkie Base Setup –
DTMF Detect
31-02-01 Internal Paging Group
Assignment – Internal Paging
Group Number
2 - 2048
Description/Comments
If an Automated Attendant caller
dials an extension that does not
answer, the call waits this time
before rerouting to the Ring Group
specified in Program 25-03 and
Program 25-04. This time also
affects unanswered DISA calls.
Set the time for disconnecting a
call after it is re-transferred to a
ring group by VRS/DISA.
Set up password (six digits).
Enter the password DISA callers
must dial before the system allows
them to record, listen to or erase
VRS messages.
Used to assign a speed dial
number when the wrong number is
received.
Used to assign a speed dial
number when a dial tone times-out
and the target extension does not
answer or is busy.
Assign a timer, per single digit
table, required to expire before the
allocated single digit entry is
applied.
Version 9000 or higher

software is required.
1 = On setting detects DTMF
signal during sending VRS
message for DID/DISA call.
0 = Off setting does not detect
DTMF signal during sending VRS
message for DID/DISA call.
Assign extensions to Internal
Paging Groups (i.e., Page Zones).
UNIVERGE SV8100
Assigned Data
1
0~64800 (seconds)
(default = 0)
0~64800 (seconds)
(default = 60)
Dial (Six digits fixed)
#
(0~9, , )
(default not assigned)
#
1~9, 0, ,

Six digits fixed
(default not assigned)
Speed Dial bin number
0~1999

(default = 1999)
Version 3000 software
or higher is required
Speed Dial bin number
0~1999.

(default = 1999)
Version 3000 software
or higher is required.
0~64800
(0 = No Setting)
(default = 0)
0 = Off
1 = On
(default = 1)
0~64
(0 = No Setting)
Default:
0 for IP Station
1 for TDM Station
Voice Response System (VRS)
Level
2 3






