Install The Light And Lens; Install The Lights; Attach The Emergency Release Rope And Handle - Craftsman 139.53225SRT Owner's Manual

1/4, 1/3 and 1/2 hp garage door opener
Hide thumbs Also See for 139.53225SRT:
Table of Contents

Advertisement

Installation Step 7
Install the Light and the Lens

Install the lights

• Install a 75 watt maximum light bulb in the socket.
The light will turn ON and remain lit for
approximately 4-1/2 minutes when power is
connected. Then the light will turn OFF.
• If the bulb burns out prematurely due to vibration,
replace it with a standard neck "Garage Door
Opener" bulb.
Install the lens
(except for Model 53225)
• Apply slight pressure on the sides of the lens and
slide the tabs into the slots in the end panel.
• Reverse the procedure to remove the lens.
Installation Step 8
Attach the Emergency Release
Rope and Handle
Trolley
Rope
Overhand
Knot
Overhand
Knot
Trolley
Release Arm
Emergency
Release Handle
19
Lens Guide
Light Lens
WARNING
Do not use the red handle to pull the door
open or closed. The rope knot could become
untied and you could fall. Use the emergency
release only to disengage the trolley and, if
possible, only when the door is closed.
Garage doors are heavy. If the door is open
when the handle is pulled, the door could
close inadvertently if it is not properly
balanced. Serious injury may result to persons
under the door. Make sure the doorway is clear
of persons and obstructions before pulling
handle when door is open.
• Thread one end of the rope through the hole in the
top of the red handle so "NOTICE" reads right side
up as shown. Secure with an overhand knot.
The knot should be at least 1" from the end of the
rope to prevent slipping.
• Thread the other end of the rope through the hole in
the release arm of the outer trolley.
• Adjust rope length so the handle is 6 feet above the
floor. Secure with an overhand knot.
If it is necessary to cut the rope, heat seal the cut
end with a match or lighter to prevent unraveling.
Lens Slot
Lens Tab
75 Watt Max.
Light Bulb

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents