Starting The Pbx - Panasonic KX-NCP500 Getting Started

3.1 Starting the PBX

3.1 Starting the PBX
WARNING
•
Use only the AC power cord included with the PBX.
•
Make sure that the AC outlet is properly earthed, then securely connect the 3-pin AC plug
including the earthed pin.
CAUTION
•
Before touching the System Initialise Switch, discharge static electricity by touching ground or wearing
an earthing strap.
•
Once you have started the PBX and if you unplug the PBX, do not perform the following procedures
to start the PBX again. Otherwise, your programmed data is cleared.
•
The power supply cord is used as the main disconnect device. Ensure that the AC outlet is located
near the equipment and is easily accessible.
Notice
The SD Memory Card must be inserted in the SD Memory Card slot of the IPCMPR card before startup.
Note
The PBX will continue to be powered even if the power switch is turned "OFF".
1.
Slide the System Initialise Switch to the "SYSTEM INITIALIZE" position.
16 Getting Started
RUN Indicator
System Initialise Switch
Reset Button