Specifications - Ferris IS1500Z Series Operator's Manual

Specifications

Specifications
NOTE: Specifications are correct at time of printing and are subject to change without notice.
ENGINE:
19HP* Kawasaki
Make Kawasaki
Model FS600V-DS00-S
Horsepower 19 @ 3600 rpm
Displacement 36.8 Cu. in (603 cc)
Electrical System 12 Volt, 15 amp. charging coil,
Battery: 340 CCA
Oil Capacity 1.8 US Qt. ( 1.7 L) w/ Filter
20HP* Kawasaki
Make Kawasaki
Model FX600V
Horsepower 20 @ 3600 rpm
Displacement 36.8 Cu. in (603 cc)
Electrical System 12 Volt, 15 amp. Alternator,
Battery: 340 CCA
Oil Capacity 1.8 US Qt. ( 1.7 L) w/ Filter
25HP* Kawasaki
Make Kawasaki
Model FH721V
Horsepower 25 @ 3600 rpm
Displacement 41.2 Cu. in (675 cc)
Electrical System 12 Volt, 13 amp. Alternator,
Battery: 340 CCA
Oil Capacity 2.0 US Qt. ( 1.9 L) w/ Filter
26HP** Briggs & Stratton Cyclonic
Make Briggs & Stratton
Model 44P977-0111-G5
Horsepower 26 @ 3600 rpm
Displacement 44.2 Cu. In (724 cc)
Electrical System 12 Volt, 16 amp. Alternator,
Battery: 340 CCA
Oil Capacity 2.0 US qt. (1.9 L) w/ filter
CHASSIS:
Fuel Tank Capacity: 6 Gallons (22.7 L)
Rear Wheels Tire Size: 22 x 11.00 -10
Inflation Pressure: 15 psi (1,03 bar)
Front Wheels Tire Size: 13 x 5.00 - 6
Inflation Pressure: 25 psi (1,72 bar)
TRANSMISSIONS:
(S/N: 2013824223 & Below)
LH (Pump) PJ-3HBQ-FV1F-XXXX (#5100670)
(Wheel Motor) HGM-15E-3138 (#5100407)
RH (Pump) PJ-3KBQ-FV1F-XXXX (#5100671)
(Wheel Motor) HGM-15E-3132 (#5100410)
(S/N: 2013824224 - 2014295181)
LH (Pump) PK-3HBQ-FV1F-XXXX (#5102174)
(Wheel Motor) HGM-15E-3138 (#5100407)
RH (Pump) PK-3KBQ-FV1F-XXXX (#5102175)
(Wheel Motor) HGM-15E-3132 (#5100410)
46
(S/N: 2014295182 - 2015250504)
LH (Pump) PK-3HBQ-FV1F-XXXX (#5102174)
(Wheel Motor) HGM-15C-4026 (#5100877)
RH (Pump) PK-3KBQ-FV1F-XXXX (#5102175)
(Wheel Motor) HGM-15C-4026 (#5100877)
S/N: 2015250505 & Above)
LH (Pump) PK-3HBQ-FV1F-XXXX (#5102174)
(Wheel Motor) TF0240LS080AAKZ (5102682)
RH (Pump) PK-3KBQ-FV1F-XXXX (#5102175)
(Wheel Motor) TF0240LS081AAKZ (5102681)
Type Pump and Wheel Motor
Hydraulic Fluid Mobil 1™ 15W-50 synthetic oil or
Castrol Syntec™ 5W-50 oil
Speeds Forward: 0-10 MPH (0-16.09 km/h)
@ 3400 rpm Reverse: 0-5 MPH (0-8.05 km/h)
Continuous Torque 222 ft. lbs. (301 N.m.)
Output
Maximum Weight 750 lbs. (340 Kg)
on Axle
DIMENSIONS:
Overall Length 80" (203 cm)
Overall Width 61" (155 cm) - 48" models
65" (165 cm) - 52" models
Height 65" (165 cm)
Weight (apx..)
With 48" Mower Deck 978 lbs. (444 kg)
With 52" Mower Deck 1012 lbs. (459 kg)
*Actual sustained equipment horsepower will likely be lower due to
operating limitations and environmental factors.
**Power Rating
The gross power rating for individual gas engine models is labeled
in accordance with SAE (Society of Automotive Engineers) code
J1940 (Small Engine Power & Torque Rating Procedure), and rating
performance has been obtained and corrected in accordance with
SAE J1995 (Revision 2002-05). Torque values are derived at 3060
RPM; horsepower values are derived at 3600 RPM. Net power
values are taken with exhaust and air cleaner installed whereas
gross power values are collected without these attachments. Actual
gross engine power will be higher than net engine power and is
affected by, among other things, ambient operating conditions and
engine-to-engine variability. Given the wide array of products on
which engines are placed, the gas engine may not develop the
rated gross power when used in a given piece of power equipment.
This difference is due to a variety of factors including, but not limited
to, the variety of engine components (air cleaner, exhaust, charging,
cooling, carburetor, fuel pump, etc.), application limitations, ambient
operating conditions (temperature, humidity, altitude), and engine-
to-engine variability. Due to manufacturing and capacity limitations,
Briggs & Stratton may substitute an engine of higher rated power
for this Series engine.
www.ferrisindustries.com