Test Equipment - Panasonic Digital Palmcorder PalmSight PV-DV100 Service Manual

TEST EQUIPMENT

To do all of these electrical adjustments, the following equip-
ments are required.
1. Dual-Trace Oscilloscope
Voltage Range: 0.001 to 50 V/Div.
Frequency Range: DC to 50 MHz
Probes: 10:1, 1:1
2. DVM (Digital Volt Meter)
3. Frequency Counter
4. Vectorscope
5. Plastic Tip Driver
6. Personal Computer
PC: IBM PC/AT or compatible
OS: MS-DOS or MS-Windows
CPU: 486 or higher
Drive: 3.5 inch 1.44 MB floppy disk drive
Port: D-Sub-9-pin Serial or D-Sub-25-pin Serial
Monitor: VGA Color
7. PC-EVR Adjustment Program (VF0D2000DV10)
Note:
Ask latest version when placing order for PC-EVR Adjust-
ment program.
8. Interface Board (LSUP0007)
9. Inter Link Cable
10. Camera Connecting Cable (LSUP0010)
11. 49 % Transmission Tape (VFK1217)
12. Color Bar Standard Tape (VFM3010EHS)
(Keeping condition: Keep at 18 °C ~ 28 °C)
13. Reel FG Adjustment Cassette
(Refer to "How to make the Reel FG Adjustment Cassette".)
14. White Chart (VFK1164TFWC2)
15. Color Bar Chart (VFK1164TFCB2)
16. Light Box and AC Adaptor
17. Infinity Lens (with Focus Chart) (VFK1164TCM02)
18. AC Adaptor (for DVC)
Fig. E1
19. 49 mm Attachment Ring (VFK1164TAR49)
20. Color Conversion Filter (C10)
21. Color Conversion Filter (C14) (VFK1164TFCT2)
How to make the Reel FG Adjustment
Cassette
1) Purchase a DV cassette tape locally.
2) Remove 4 Screws on the DV cassette tape.
3) Remove the Top Case.
4) Take out the Wheels with tape.
5) Undo the whole tape to cut the portions as shown.
6) Reassemble the DV cassette tape.
Note:
Reinstall the Top Case with its door opened.
Reassembly Note:
Be sure to install each part in the original position when parts
are out of place as the DV cassette tape disassembled.
Top Case
Cut
Wheel
Screw
Parts location in DV cassette tape
Wheel
3-5
Open
Cut
Wheel
Release
Lever
Screws
Fig. E2-1
Release
Lever
Wheel
Fig. E2-2