Setting The Clock; Turning Off The Power Automatically - JVC UX-P450 Instructions Manual

3
Adjust the parameter.
4
Repeat steps 2 to 3 to adjust other parameters.
To erase the screen, press VFP again while holding SHIFT.

Setting the Clock

Without setting the built-in clock, you cannot use Daily
Timers, Recording Timer (see page 31) and Sleep Timer.
• To correct a misentry during the process, press CANCEL
or CLOCK/TIMER. You can return to the previous step.
1
Activate the clock setting mode.
CLOCK/
TIMER
• If you have already adjusted the clock before, press the
button repeatedly until the clock setting mode is
selected.
2
Adjust the hour.
3
Adjust the minute.
Now the built-in clock starts working.
To check the current clock time during play
DISPLAY
Source information
• While playing a DVD and MP3/WMA, you cannot check
the current clock time (see page 9) .
ENTER
Remote
ONLY
SET
SET
Clock
Turning Off the Power
Remote
Automatically
ONLY
To turn off the unit after playback is over—Auto
Standby
SLEEP
A.STANDBY
(at the same time)
When Auto Standby is in use, the A.STANDBY indicator
lights on the display.
When disc play stops, the A.STANDBY indicator starts
flashing. If no operation is done for about 3 minutes while
the indicator is flashing, the System turns off (stands by)
automatically.
• Auto Standby does not work while you are listening to
radio (FM/AM) and the external component (AUX).
To turn off the unit after a certain period of time
—Sleep Timer
1
Specify the time (in minutes).
SLEEP
A.STANDBY 10 20 30
2
Wait until the set time goes off.
To check the time remaining until the shut-off time
SLEEP
A.STANDBY
• If you press the button repeatedly, you can change the shut-
off time.
On
Canceled
60 90 120 150
Canceled
SLEEP
17