Software Specifications; Function Description; Radio Modes; Pc Programming Mode - HYT TC-610 Service Manual

Software Specifications

Function Description

1. Available Channels: 1 to 16 channels
2. Channel Spacing: 25KHz/12.5KHz
3. Channel Step: scan channels in steps of 5/6.25/10/12.5KHz
4. Tx/Rx Indication (red/green LED)
5. CTCSS/CDCSS Encode & Decode (CTCSS: 38 groups; CDCSS: 83 groups; the CTCSS squelch
tail reverse method is selectable at 180/120 degrees.)
6. Low Battery Alert
7. Auto Battery Save
8. Unlock Detect and Alarm
9. Selectable Squelch Level (0-9)
10. Monitor
11. Time-Out Timer (TOT)
12. Squelch Tail Elimination
13. PC Programming (including PC manual adjustment and PC auto adjustment)
14. High/Low Power Select (2.0/5.0W)
15. Wide/Narrow Band Compatibility
16. Busy Channel Lockout
17. Wired Clone
18. Battery Power Indication
19. Manual Adjustment
20. VOX and Selectable Sensitivity Level (1-5)

Radio Modes

User Mode
User Mode is for conventional communication operations. Turn on the power, and the radio enters User
Mode directly.

PC Programming Mode

In User Mode, the PC programming software triggers PC Programming Mode by communication via a
special communication protocol. In this mode, functions can be set and parameters can be adjusted via
the PC programming software (including user version and factory version).
Wired Clone Mode
Description
Wired Clone Mode is a separate mode. To enter other modes, the radio must be turned off and back on.
Wired Clone Mode is classified into User Wired Clone Mode and Factory Wired Clone Mode.
TC-610/620 Service Manual
8