User Wired Clone Mode; Factory Wired Clone Mode; Wired Clone; Manual Adjustment Mode - HYT TC-610 Service Manual

1. User Wired Clone Mode

Connect the two radios with the cloning cable. Power on the source radio while holding down the SK2
key on it. The radio enters Wired Clone Mode in two seconds. Rotate the Radio On-Off knob clockwise
to power on the target radio, and the radio enters User Mode. This mode clones the parameter data in
EEPROM of the source radio into that of the target radio. The transferred data only includes channel
data and shared parameters, excluding adjustment data, information of model version, serial number,
etc.

2. Factory Wired Clone Mode

Short out the SELF pin of the source radio' s MCU and connect the two radios with the cloning cable.
Power on the source radio while holding down the SK2 key on it. The radio enters Wired Clone Mode in
two seconds. Rotate the Radio On-Off knob clockwise to power on the target radio, and the radio enters
User Mode. The transferred data includes all data in EEPROM except the serial number, and the switch
icon of Manual Adjustment Inhibit.
Process

Wired Clone

1. The LED flashes orange once when the source radio enters Wired Clone Mode. Press the SK2 key
again to copy data into the target radio.
2. During cloning, the LED of the source radio flashes red, while the LED of the target radio flashes
green. When cloning is completed, the red LED of the source radio and green LED of the target
radio go out, preparing for the next cloning.
3. During cloning, if an abnormal situation occurs, cloning will be terminated. The red LED of the
source radio goes out, preparing for the next cloning.
4. When cloning is completed, the source radio returns to the preparing status. Press the SK2 key to
clone again.

Manual Adjustment Mode

Power on the radio while holding down the PTT key and SK2 key. The radio enters Manual Adjustment
Mode.
Note: The operation is controlled by the switch of Manual Adjustment Inhibit in the programming
software. When the adjustment function is disabled, the radio can not enter this mode. This can prevent
radio users' accidental entry and parameter changes, which will affect the performances of the radio.
During production, disable the adjustment switch, to prevent radio users from accidentally entering and
changing adjustment values after the values are adjusted. The adjustment values can only be reset in
the factory set mode and are adjusted again according to the requirements. They can not be changed in
any other mode.
Adjustment Description
1. Enter Manual Adjustment Mode
Hold down the PTT key and SK2 key simultaneously for 2s at least to power on the radio. The orange
LED (red LED + green LED) lights, indicating the entry into the adjustment mode. Release the keys to
TC-610/620 Service Manual
9