Adjustment Of High-Voltage Transformer; Adjustment - Toshiba e-STUDIO 163 Service Handbook

3.5

Adjustment of High-Voltage Transformer

When replacing the high-voltage transformer, checking each output adjustment of main charger, devel-
oper bias, transfer charger and separation charger is needed.
3.5.1

Adjustment

[ 1 ] Preparation
Items to check
Process Unit
High-Voltage Transformer Jig Install the high-voltage transformer jig in the equipment.
Digital (+) terminal
Tester
(–) terminal
Function switch
Full-scale (range)
Remarks
How to turn ON the power
Note
December 2005 © TOSHIBA TEC
Developer Bias
Take off from the equipment. (Not used)
Note: Note:
Connect the green cable of the high-voltage transformer jig to ground on
the equipment frame. Refer to
age transformer jig".
Connect with the black Connect with the red
cable of the high-volt- cable (thick line) of the
age transformer jig. high-voltage trans-
former jig.
Connect with the white cable of the high-voltage transformer jig.
1000 V
Use a digital tester with an input resistance of 10 MΩ (RMS value) or higher.
Attach the door switch jig and start with the adjustment mode [05] while the front
cover opened. Then press the front cover opening/closing switch.
Refer to P. 3-30 "[B] Refer to
Connection for devel- "[C] Connection for
oper bias adjustment". main charger adjust-
ment".
3 - 27
Transfer
Main Charger
Charger
P. 3-28 "[A] Installation of the high-volt-
Connect with the red cable
(thin line) of the high-voltage
transformer jig.
DC
P. 3-30 Refer to
nection for transfer/separation
charger adjustment".
e-STUDIO163/203 ADJUSTMENT
Separation
Charger
2 V
P. 3-31 "[D] Con-
3