Installer Setup - Trane TCONT600AF11MA Installation Instructions Manual

Installer setup

Follow the procedure below to configure the Comfort Control to match the
installed heating/cooling system, and customize feature operation as desired.
To begin, press and hold the
buttons until the display changes
Setup Function
1 System type
3 Fan control
(heating)
5 Heating cycle rate
(CPH: cycles/hour)
9 Compressor
cycle rate (CPH)
12 System setting
adjustment
13 Adaptive Intelligent
Recovery™
14 Temperature
display
15 Compressor
protection
16 Schedule format
27 Heat temperature
range stops
28 Cool temperature
range stops
31 Dehumidification
Control
and
fan
Settings & Options
0 Gas, oil or electric heat with air conditioning
1 Heat pump
2 Heat only (2-wire systems/power to open & close zone valves/
normally open zone valves)
3 Heat only with fan
 Cool only
0 Gas or oil furnace — equipment controls fan in heating
1 Electric furnace — Comfort Control controls fan in heating
5 For gas or oil furnaces of less than 90% efficiency
1 For steam or gravity systems
3 For hot water systems & furnaces of over 90% efficiency
9 For electric furnaces
[Other cycle rate options: 2, , , , 8, 10, 11 or 12 CPH]
3 Recommended for most compressors
[Other cycle rate options: 1, 2, , 5 or  CPH]
0 Manual changeover (Heat/Cool/Off)
1 Auto changeover (Heat/Cool/Auto/Off) **See page 9
2 Auto changeover only (Auto) **See page 9
1 On **See page 9
0 Off
0 Fahrenheit
1 Celsius
5 Five-minute compressor off time **See page 9
[Other options: 0, 1, 2, 3 or -minute off time]
0 5/2 (programmable weekdays and weekends)
1 5/1/1 (weekdays, Saturday & Sunday programmable)
90 Highest heating temperature setting
0-89 Heating temperature range (increments of 1°F, or 0.5°C)
60 Lowest cooling temperature setting
1-99 Cooling temperature range (increments of 1°F, or 0.5°C)
1 Cooling Droop
2 Cooling Droop with Comfort-R
3 Cooling Droop with Comfort-R
0 None
Function
number
Done
Press or
Press
next
Press
done
(BOLD is "as shipped" settings)
(15 seconds Fan Delay)
TM
(30 seconds Fan Delay)
TM

Setting
Next
to change settings
to advance to next function
to exit and save settings