Playing At Random - Random Play - JVC UX-F70MD Instructions Manual

To check the program contents
Before playing, you can check the program contents by
pressing ¢ or 4.
• ¢ : Shows tracks in the programed order.
• 4 : Shows the programed tracks in the reverse order.
To modify the program
Before or after playing, you can erase the last programed
track by pressing CANCEL. Each time you press the
button, the last programed track is erased from the
program.
To add tracks in the program before you start play,
press the number buttons to select track numbers you want
to add.
To erase the entire program, press CD open/close 0 to
eject the CD.
• Turning off the unit will also erase the program.
If you try to program a 33rd step
"MEMORY FULL" will appear on the display.
If your entry is ignored
You have tried to program a track number that does not exist on the
CD (for example, selecting track 14 on a CD that only has 12
tracks.) Such entries are ignored.
If the total playing time is 100 minutes (one hour
and 40 minutes) or more
The total playing time will not be shown. ("– – : – –" will appear.)
Playing at Random — Random Play
The tracks of a loaded CD will play at random.
On the remote control ONLY:
1
Load a CD.
2
Press CD 3 / 8, then 7.
The source is changed to "CD."
3
Press PLAY MODE repeatedly until "RANDOM"
appears on the display.
• Each time you press the button, play mode changes
as follows:
PROGRAM
(Program play)
4
Press CD 3 / 8.
The tracks are played at random.
CD indicator
The current
track
Play mode
Random play stops when all the tracks are played once.
To stop during play, press 7.
To skip the current track, press ¢.
• You cannot go back to the previous tracks by pressing
4.
To exit from Random play mode, press PLAY MODE
repeatedly so that the unit enters another playback mode
(Normal play or Program play mode) before or after play.
– 20 –
Continued
RANDOM
(Random play)
Normal play
Elapsed playing time