Connecting Speakers - JVC UX-F70MD Instructions Manual

AM antenna
1
2
3
AM loop antenna
(supplied)
1
If cords are covered with insulation, twist the core
of the cord at the end of each cord, then remove the
insulation.
2
Connect the AM loop antenna to the AM LOOP
terminals as illustrated.
3
Turn the AM loop antenna until you have the best
reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered
wire to the AM EXT terminal and extend it horizontally.
The AM loop antenna must remain connected.
For better reception of both FM and AM
• Make sure the antenna conductors do not touch any other
terminals and connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the AC power cord.
Vinyl-covered wire
(not supplied)
– 7 –

Connecting Speakers

To attach spacers
If you want to place the speakers beside the main unit, it is
recommended to leave a space (1 cm) between the main
unit and the right speaker for ventilation.
It is recommended to attach the spacers (supplied) to the
right speaker as the illustration below:
The main unit
Opening for ventilation
By peeling the cover seal from the spacers, you can
attach them to the right speaker.
To remove the speaker grilles
The speaker grilles are removable as the illustration below.
Holes
To remove the speaker grille, insert your fingers at the top
of the speaker grille, then pull towards you. Do the same at
the bottom.
To attach the speaker grille, put the projections of the
speaker grille into the holes of the speaker.
The right speaker
Spacers (supplied)
Projections
Speaker grille