Playing Back A Portable Audio Device - JVC SP-UXG70 Instructions Manual

Playing Back a Portable Audio Device

By using QP Link (Quick Portable Link), you can easily start
playing back a portable audio device connected to the LINE
IN jack (see page 5).
• Make sure to set the volume of your portable audio device
loud enough so that the System can detect the sound signal.
To activate QP Link
QP LINK
CLOCK/TIMER
(while holding...)
When QP Link is activated, connecting a portable device to
the LINE IN jack and starting playback performs the
following:
• While listening to another source...
Changes the source to LINE automatically. (If you change
from LINE to another source, QP Link will be canceled.)
• While the System is on standby...
Turns on the System and activates the LINE source
automatically (except when the display is turned off).
MP3 WMA MONO ST TA NEWS INFO A.STBY
1 DISC ALL A–B QP Link PG PL USB AHB PRO S.TURBO
GROUP RANDOM PRGM 3D PHONIC
PRGR. B.S.P. BONUS
While QP Link plays back the device...
ST TA NEWS INFO A.STBY
MP3 WMA MONO
1 DISC ALL A–B QP Link
PG PL USB AHB PRO S.TURBO
GROUP RANDOM PRGM 3D PHONIC PRGR. B.S.P. BONUS
INFO
Remote
ONLY
QPLINK ON
QPLINK OFF
REC
SLEEP
1 2 3
REC
Bubbles appear when
QP Link works.
REC
Bubbles disappear
SLEEP
REC 1 2 3
when the sound signal
stops or is too weak.
Playing Back from the PC
This System is equipped with a USB AUDIO terminal on the
front panel. You can connect your PC to this terminal and
enjoy sound reproduced through your PC.
When you connect your PC for the first time, follow the
procedure below.
• Remember you cannot send any signal or data to your PC
from this System.
IMPORTANT
• Always set volume to "VOL MIN" when connecting or
disconnecting the other equipment.
How to install the USB drivers
1
Turn on your PC and start running Windows
Windows R 98SE*, Windows
or Windows R XP*.
• If the PC has been turned on, quit all the applications
running.
2
Select "USB" as the source.
Remote control:
USB
3
Connect the System to the PC using a USB cable (not
supplied).
At the front panel
USB cable
• Use "USB series A plug to B plug" cable less than
3 m.
4
The USB drivers are installed automatically.
To playback sound on the PC
Refer to the manuals supplied with the sound reproduction
application installed in the PC.
• Noise and static electricity may stop the sound through the
USB connection. In this case, do the following operations:
– Disconnect and connect the USB cable again
– Restart the music software on your PC
– Turn off and on the System
* Microsoft R , Windows R 98, Windows
Windows R Me, Windows
registered trademarks of Microsoft corporation.
INFO
R 98*,
R Me*, Windows R 2000*,
Main unit:
PC
R 98SE,
R 2000 and Windows R XP are
11