JVC SP-UXG70 Instructions Manual page 8

~
Powered subwoofer
From the powered
subwoofer
(not supplied)
The subwoofer connected can reproduce the bass sounds
recorded in front left and right channels, but cannot
reproduce the LFE signals in DVD multi-channel discs.
• Before plugging the unit to the main supply, make sure that
the powered subwoofer is turned off.
Ÿ
AM/FM antenna
To assemble the AM loop antenna
To connect AM/FM antenna
AM loop antenna
(supplied)
FM antenna (supplied)
Extend it so that you can obtain the best
reception.
4
For better AM/FM reception
SUB -
WOOFER
OUT
Vinyl-covered wire
(not supplied)
Extend it horizontally.
• Disconnect the supplied FM antenna, and connect to an
outdoor FM antenna using a 75
connector (IEC or DIN45325).
!
TV/monitor
Connect only component cord or Scart cord at one time.
Green
• To select progressive scanning mode (see page 14), use
COMPONENT jacks.
Scart cord (not supplied)
• After connecting a TV, select the proper video signal mode
according to the connection method. See "Changing the
Scanning Mode" on page 14.
AM loop antenna (supplied)
Keep it connected.
FM outdoor antenna
(not supplied)
Ω
wire with coaxial type
Red
Blue
Component video cord
(not supplied)
• This connection sends
the video signal
(Composite, RGB or
Y/C) and receives audio
signal from TV. To listen
to the TV sound, see
page 8.